5131B

The 5131 transmitter can be configured with a standard PC and the Loop Link communications unit.

Independent channel jumper selectable inputs for current/voltage or temperature.
Current input programmable in range the 0...100 mA and voltage inputs in the range 0...250 VDC.
Linearized, electronic temperature measurement with RTD or TC sensor.
Conversion of linear resistance variation to a standard analog current / voltage signal, for example from solenoids and butterfly valves or linear movements with attached potentiometer.
4- or 3-wire connection with automatic cable compensation or 2-wire connection with programmable cable compensation.
Configurable sensor error detection including NAMUR NE43.

The 2-channel version has full galvanic isolation between the channels.
Separation of circuits in PELV/SELV installations.
I.S. barrier for temperature sensors, potentiometers and current / voltage signals.

Supply
Supply voltage	7.5...35 VDC
Fuse	50 mA SB / 250 VAC
Isolation voltage
Isolation voltage, test / working	3.75 kVAC / 250 VAC
PELV/SELV	IEC 61140
Response time
Temperature input, programmable (0...90%, 100...10%)	400 ms...60 s
mA / V input (programmable)	250 ms...60 s
Programming	Loop Link
Signal / noise ratio	Min. 60 dB (0...100 kHz)
Updating time	115 ms (temperature input) 75 ms (mA / V / mV input)
Signal dynamics, input	22 bit
Signal dynamics, output	16 bit
Effect of supply voltage change	< 0.005% of span / VDC
EMC immunity influence	< ±0.5% of span
Extended EMC immunity: NAMUR NE21, A criterion, burst	< ±1% of span

Common input specifications
Max. offset	50% of selected max. value
RTD input
RTD type	Pt100, Ni100, lin. R
Cable resistance per wire	10 Ω (max.)
Sensor current	Nom. 0.2 mA
Effect of sensor cable resistance (3-/4-wire)	< 0.002 Ω / Ω
Sensor error detection	Yes
TC input
Thermocouple type	B, E, J, K, L, N, R, S, T, U, W3, W5, LR
Cold junction compensation (CJC)	< ±1.0°C
Sensor error current	Nom. 30 μA
Sensor error detection	Yes
Current input
Measurement range	0...100 mA
Min. measurement range (span)	4 mA
Input resistance: Supplied unit	Nom. 10 Ω + PTC 10 Ω
Input resistance: Non-supplied unit	RSHUNT = ∞, VDROP < 6 V
mV input
Measurement range	-150...+150 mV
Voltage input
Measurement range	0...250 VDC
Min. measurement range (span)	5 mV
Input resistance	Nom. 10 MΩ (≤ 2.5 VDC) Nom. 5 MΩ (> 2.5 VDC) Nom. 10 MΩ (mV input)

Current output
Signal range	4…20 mA
Min. signal range	10 mA
Load (@ current output)	≤ (Vsupply -7.5)/0.023 [Ω]
Load stability	≤ 0.01% of span / 100 Ω
Current limit	≤ 28 mA
Sensor error indication	Programmable 3.5…23 mA
NAMUR NE43 Upscale/Downscale	23 mA / 3.5 mA
of span	= of the presently selected range