Loop-powered LCD indicator
- 4 digit 1/8 DIN (48 x 96 mm) loop-powered LCD display
- Easy push-button configuration
- Backlit LCD display is readable in low light conditions
- Display can be mounted in the safe area or in I.S. / Ex zone
- The 5531 indicator is powered by the 4 to 20 mA current loop and is easily scaled to display the correct process value.
- Because it does not require separate power wiring, the 5531 is perfect for remote display of process loops.
- The 5531B can be mounted in Ex Zone 1.
- The 5531B1 Ex display includes the 8501 enclosure and can be mounted in Ex Zone 2 or 22 (gas or dust).
- The 5531B2 includes the 8501 enclosure and can be mounted in Ex Zone 1, 2, 21 or 22 (gas or dust).
- With a full measurement range of 3.6 to 23 mA, the 5531 is NAMUR NE43 compliant.
- The display can be push-button scaled to any range between -9999 to 9999, and reverse display action is possible.
- The LCD backlight can be set to half or full intensity for easy viewing in low light conditions.
- The display only requires 1.5 VDC, (75 Ω loop load), with the backlight turned off.
- The input is HART transparent.
- The front push-buttons can be disabled to prevent unauthorized adjustment.
Mounting / installation
- Once panel mounted with the included gasket, the 5531 provides IP65 ingress protection.
Metrology Pattern Approval (MPA)
|Operating temperature||-20°C to +60°C|
|Storage temperature||-20°C to +60°C|
|Relative humidity||< 95% RH (non-cond.)|
|Protection degree||IP65, from front|
|Dimensions (HxWxD)||48 x 96 x 120 mm|
|Cut out dimensions||44.5 x 91.5 mm|
|Weight approx.||200 g|
|Cable glands and cable diameter||M16 x 1.5 / Ø 5...8 mm|
|Wire size, connector terminal 1 - 4||0.13...2.08 mm2 / AWG 26...14 stranded wire|
|Supply voltage||Input loop-powered|
|Response time (0...90%, 100...10%)||< 1 s|
|EMC immunity influence||< ±0.5% of span|
|Signal / noise ratio||> 60 dB|
|Updating time||500 ms|
|Measurement range||3.6...23 mA|
|Loop error detection, 4...20 mA: Low||~ < 3 mA|
|Loop error detection, 4...20 mA: High||~ > 24 mA|
|Input voltage drop, without backlight||< 1.5 V @ 20 mA|
|Input voltage drop, with half backlight||< 6.5 V @ 20 mA|
|Input voltage drop, with full backlight||< 10.5 V @ 20 mA|
|Display readout||± 9999 (4 digits)|
|Digit height||16 mm|
Observed authority requirements
KEMA 05ATEX1044 X (5531A/B1)
KEMA 05ATEX1105 X (5531B/B2)
|EAC Ex||RU C-DK.HA65.B.00355/19|