Artiklar 0
4511
 
 

4511

 

Communication enabler

 

  • Programming display for system 4000 and 9000 devices
  • Modbus RTU protocol interface over RS-485
  • Monitor process value from the built-in display
  • High 2.5 kV isolation to host unit
  • Shielded RJ45 connector on top
  1. Overview +

  2. Technical details +

  3. Accessories +


Application

  • The 4511 detachable display adds Modbus RTU RS-485 serial communications to all current and future 4000/9000 units.
  • The unit converts a wide array of sensors and analog device signals measured by the system 4000 like uni- and bipolar mA and voltage signals, potentiometer, Lin. R, RTD and TC, to a Modbus communication line signal.
  • When mounted on a system 9000 device any signal coming from or going to I.S. classified area, like AI, AO, DI and DO signals, can be converted to a Modbus network.
  • All individual unit operating parameters can easily and quickly be configured by using the Modbus communication or by using the front display menu.
  • The easily readable 4511 display can be used to read the process signal, simulate the output signal, indicate sensor errors and internal device errors.

Technical characteristics

  • 4511 has full 4501 functionality for unit programming, process signal monitoring and diagnostics handling.
  • Modbus RTU protocol is supported using a serial RS-485 communication wiring.
  • Multidrop half-duplex connection via shielded RJ45 connector.
  • High safe galvanic isolation of 2.5 kVAC between the serial wiring and the connected system 4000/9000 units.
  • Modbus parameters such as address, baud rate, stop bit(s), and parity bit are configured from the 4511 display, which also stores parameters.

Mounting / installation / programming

  • Mounting in Zone 2 / Div 2.
  • The 4511 can be moved from one device to another. The individual system 4000/9000 unit configuration of the first device can be saved and downloaded to subsequent devices.
  • Programmed parameters can be protected by a userdefined password.
  • When mounted on devices that are installed upside down, a menu item allows the display on the 4511 to be rotated 180o and the up/down buttons to switch function.

Data sheet


ATEX certificate


IECEx certificate


UL certificate


FM certificate


DNV marine certificate


EAC declaration


Metrology Pattern Approval (MPA)


Environmental Conditions

Operating temperature -20°C to +60°C
Storage temperature -20°C to +85°C
Relative humidity < 95% RH (non-cond.)
Protection degree IP20
Installation in Pollution degree 2 & meas. / overvoltage cat. II

Mechanical specifications

Dimensions (HxWxD) 73.2 x 23.3 x 26.5 mm
Dimensions (HxWxD) w/ 4000/9000 unit 109 x 23.5 x 131 mm
Weight approx. 100 g
Connection RJ45 - shielded

Common specifications

Supply

Max. required power ≤ 0.15 W

Isolation voltage

Isolation voltage, test / working 2.5 kVAC / 250 VAC reinforced isolation

Response time

Response time < 20 ms
Signal / noise ratio > 60 dB
Update rate > 50 Hz
Extended EMC immunity: NAMUR NE21, A criterion, burst No loss of communication
Signal type RS-485 half duplex
Serial protocol Modbus RTU
Modbus mode RTU - slave
Devices on an RS485 line Up to 32 (w/o a repeater)
Data rates, baud 2400, 4800, 9600, 19200, 38400, 57600, 115200
Automatic baudrate detection Yes - can be configured ON or OFF
Parity Even, Odd, None
Stop bit(s) 1 or 2
Digital addressing 1...247
Response delay 0...1000 ms

Observed authority requirements

EMC 2014/30/EU
LVD 2014/35/EU
EAC TR-CU 020/2011

Approvals

DNV-GL Marine Stand. f. Certific. No. 2.4
ATEX 2014/34/EU DEKRA 13ATEX0098 X
IECEx DEK 13.0026 X
FM 0003049132-C
UL UL 61010-1
Din förfrågan har skickats. - 0 Artiklar på din lista
Produktbeskrivning Antal
Vänligen ange artikelnummer och ev. variant (se datablad för mer info) – eller ange “Artikelnummer okänt”
Er kontaktinformation
Bläddra vidare
Inga produkter har lagts till i listan…
Du har inga produkter på listan…

När du ser dig omkring bland produkterna på vår hemsida har ni möjlighet att lägga till produkter i en lista och skicka denna lista till oss och därmed begära en offert. Du kan lägga till produkter i listan genom att klicka på ”Få en enkel offert”- knappen på de enskilda produktsidorna.

När du har skickat listan kommer vi att återkoppla till dig så snart som möjligt.

Om du inte skickar listan kommer den att vara synlig på webbplatsen i 7 dagar (vi kommer att använda oss av ”cookies” på din dator eller surfplatta)

Vi hoppas att ni finner denna funktion användbar. Gå till produktsidorna för att lägga till produkter i din lista.
Tack för din förfrågan.
Vi kommer att återkoppla till dig via telefon eller e-mail så snart som möjligt.